Wednesday, 27 April 2016

Restart Printer Brother DCP-1510 toner

Home >> Save >> Restart toner Brother DCP-1510 printer

Save on toner with continue mode


How to skip the message of "change toner" on printer Brother DCP-1510


In many of monochrome printers Brother jumps a warning "low toner" or "change toner" when they recognized that the toner is finished. However, as not all the same print, if you skip this error when prints jump totally sharp and well, you can skip this message and continue using the toner.

This is what is known as "Continue Mode" Brother toners.

Continue mode Brother



Activate "CONTINUE MODE"


"Continue mode" it serves to resume printing again despite the message that appears on the LCD screen of your Brother printer. Activating this mode may cause the quality of the prints is not as good as at home but at least we can continue to use the toner to the actual end of its useful life.

When activated "mode to continue" the printer continues releasing messages "change toner" "toner low" or "spent toner". This mode is disabled once a new toner so you'll have to activate it every time you're with a new toner is installed.

Then you leave the steps to activate the "mode continue":

  • Press the "Menu" key and select "General Settings" >> "Replace Toner".
  • Continue mode Brother
  • Now using the arrows up or down, select "Continue" and click "OK".
  • Press the "Stop / Exit" and go! Button


Look at the original post in Consejos Impresoras

No comments:

Post a comment